User Manual

From Bizfon Wiki

Using the PBX from a phone

This section will show you how to use the Bizfon 8000 PBX with a standard Voice over IP-phone. Although the usage of different phones varies significantly, you can use most of the features of the PBX in a similar way.

The access codes shown in this manual are the default codes. Your system administrator may assign different codes for the available features. In that case, you should receive a list of the functional feature codes. If the default codes have not been changed, you can see an overview on Default Feature Codes.

Many phones require that you press the Ok button (like on the cell phone) to start a call; other phones may accept pressing the pound (#) key or a check mark key instead. However, for the usage of the PBX that does not make any difference. Using Your BizTouch5-6: How to use your Biztouch 5 and 6
Using Your BizTouch8: How to use your Biztouch 8
Basic Calling: How to initiate and receive phone calls
Mailbox: Receiving and leaving voicemail messages
Call Forwarding: Redirect calls to other destinations
Redial and Call Return: Avoid entering numbers again
Parking, Pickup and Transfer: How to put a call somewhere else
Caller-ID Treatment: About anonymous calls, incoming and outgoing
Call Data Record: Send an email instead of writing down numbers
Recording Prompts: Recording prompts
Call Mixing: How to barge-in, teach and listen
Hot Desking: Changing location where to use an extension
Wakeup Call: Programming a wakeup call
For all feature codes see Feature Codes.

Web Interface

In the User Mode chapter you will see what you can do as user of the system by logging on to the built-in web server of the PBX. A special chapter on Scheduling Conferences shows you how you can use the conference server as a user.